hi friends
on ford fiesta year 2010, the ventilation does not work properly.
the fan speeds are working properly but I do not feel the wind in the cockpit.
the flaps high, low, middle, working well.
but maximum ventilation does not give a maximum of wind in the cockpit, but I hear the speed of the accelerator accelerated at every notch, so that's not the problem.
I feel that the flap OFF does not open fully ?! but I hear it shut up, and it is hidden in the box so not verifiable without removing half of the car.
I noticed when I put the engine back (I back the car), the wind is better but not at the maximum!
Nissan Consult III+ Plus V82.50.00
Date: September 2018
Consult III plus - dealer diagnostic system for Nissan / Datsun / Infiniti
Nissan Consult 3 is the new generation diagnostic system for Nissan, Datsun and Infiniti vehicles. Nissan Consult 3 is powerful, flexible and easy to use and will transform your ability to provide rapid, accurate service diagnostics for today's sophisticated Nissan, Datsun and Infiniti models and future products.
Installation:
1. Execute setup from V82.11.00 folder.
2. Execute setup from V82.50.00 folder.
Troubleshooting:
If you got an error about wrong computer please run "if you have problem on startup.reg"
If you got an error at the end of installation, check log file at "C:\CONSULT-III_plus\Logs\Installer"
Working with PassThru J2534 device:
Only Nissan VI will work at 100%.
PassThru devices are not fully supported.
You can read/clear DTCs and execute simple Work Support procedures. No datastream, no EV battery monitor, etc.
