Hi everybody, i need virgin for PSA Delphi DCM 3.5 9667175380
28346183
See atachment, read by ktag. thanks in advance.

Easily edit any text file, binary file, drive, or process on your computer. Our unique Binary Templates technology allows you to view and edit complex binary data in an easy, intuitive way. Includes a whole range of powerful analysis and editing tools. and more....
On attach link for download and activation on PM after tnx+rep

BR

Attached Files

010Editor.txt
File Type:
Downloaded:	149 times
Size:	36 bytes

Hi friends, could you check me if I did a good job of deleting egr and dpf?

Thank you in Advance

VW Touareg 2007/EDC16U31. Kess is induction:
Select the Master ECU and perform the writing, then repeat the programming procedure, but this time select the Slave ECU.

Warning: if you program only one of two ECUs, the engine will not start.
Do I have to write the file twice Master and Salve?

Today an Audi q7 3.0 240cv has arrived with an EDC17CP44 and the error code p2453. I have deleted the FAP with ADS, I do not know if it is well done, the error p2453 keeps appearing, can anybody give me a hand with this particle filter and the error? The g450 sensor has only 1 of the 2 pressure tubes, I have searched everywhere and can not find the broken sensor tube, can this fault be removed by disconnecting the sensor? if I disconnect it gives error p2452 and p2453 Thank you very much in advance, greetings to all.

Hi all, I need EGR OFF for this ECU
DENSO D3 NISSAN PATHFINDER 

thanks and rep

Attached Files

denso pathfinder flash.rar
File Type:
Downloaded:	59 times
Size:	315.16 KB

Hello 

Can some one help me with pin from this dump?

CIM Delphi 13112786 XU
MCU MC68HC08AZ60


Best regards
Tomek

Attached Files

CIM cpu 2.rar
File Type:
Downloaded:	63 times
Size:	499 bytes

Hello I have problem with rear SAM from Mercedes W203 C180 and I need Flash File 2J74Y 


002 545 78 01
5DK 007 974-00
HW:3500  SW:2600

hi
mark all forums read doesnt seem to work
when clicked it takes you back to forum main page (like it should) but if you then click view new posts it then gives you all the same posts again

Here is a collection of Radio calculators !!

link Radio calc.txt
File Type:
Downloaded:	317 times
Size:	70 bytes

This version 160115a is for high quality clones..

Has until Astra K inside.

Mine has good chip inside,firmware  1.70 and works well!

english language.

Added firmware/ocflash/cdm uninstaller in txt
My 1.70 DUMP too

SO i figured out that you have to use the flashing utility with this good dump,
->then your device will be recognised as OPCOM V2 ,and if its a good quality device,
->then you install the software,and be carefull to install the correct drivers.

->Thats the hard part,because,software opens only if you have the correct drivers installed.

I did it to 3 devices today,two of them worked fine.

See pass after clicking this sentence : Stelaras2018 :P

Attached Files

vauxcom 160115a.rar
File Type:
Downloaded:	291 times
Size:	331 bytes

FTDI_Dump_.rar
File Type:
Downloaded:	200 times
Size:	280 bytes

Hi,

Please anyone can dpf and egr off.

ktag backup

Attached Files

Peugeot 3008 SID807evo.zip
File Type:
Downloaded:	69 times
Size:	1,021.3 KB

mtool  for  all
---------------------------------operation only needed ELM327/ESL27 and M-Bus adapter!

This program (STool) is designed to correct the mileage

Attached Files

Thumbnail(s)
   

mtool.rar
File Type:
Downloaded:	159 times
Size:	123 bytes

ELM327_äîðàáîòêà_àäàïòåðà.pdf
File Type:
Downloaded:	257 times
Size:	956.75 KB

Hi guys.. Here I have strange problem with psa visteon dcu 102 from boxer..first ecu made egr off read write no problems in proces..car dont start and cant reach by obd..take back ori file and same problem(no start,no obd comunicate)find virgin file online also no go...than I find second hand ecu made backup virginize the file and gess what?same story...ecu killed again and no reach by obd..I tryed read/write with all tools in my hand ktag,kess,fgtech all same story...I heared lot of people had this problem iven with magpro x17 after boot  mode ecu dead so I am wondering if anyone now whats killed inside ecu or how to bring it back to life?thanks advanced

Hi to all. I'm looking incode for ford transit 2013 for module programming, autokeyprog or tms software does not works, i will pay for incode if someone can generate it. thanks 

giorgi

new outcode

https://mega.nz/#!W4skALJD!ZSoJD_S6bYwDq0b8WwdKY3Su2WdUEUVVi2rekUtlSGk

Hi Mates:

Someone can make immo off in this ECU.

Thanks For Help...

Attached Files

Seat Leon EDC17C46.rar
File Type:
Downloaded:	57 times
Size:	962.99 KB

Hi,
in VW Caddy 2016 year, 2.0TDI. I read SRI Reset values. 
After that I wanted to change OIL Quality in 17 - Instrument cluster (Channel 045: Oil Quality) from 2 = flexible Service Intervals (with Longlife) to 1 = fixed Service Intervals (w/o Longlife), controller accepted request, after that VCDS changed value to 0 and couldn't change it to 2 or 1 (but cotroller still was accepting values).
After reading Oil quality in Wurth WOW it shows me NULL value and I can't change value because of error.
Now when I try read SRI values it shows me "adaptation channel could not be read" (or something like that, can't remember properly).

Now when I ride red oil lamp shines. At idle sometimes. 

It has cluster like Golf 6.
Maybe someone had same problem?

RUP + REPL PLZ 

Attached Files

clip 176V.txt
File Type:
Downloaded:	152 times
Size:	50 bytes

Hello,
Please check checksum in this file. 
I am wrote my MOD files to 2x AM28F010 and car wont start, only glow plug relay clicked. 
Any ideas? maybe chk is wrong... 

Regards
MICHAL

Attached Files

Vw T4 2,5 TDI 88 ps.rar
File Type:
Downloaded:	38 times
Size:	189.82 KB

please code 
Balupunkt GAMMA
VWZ1Z3A2069313
7648231360
1JO035186E

hi please help me to remove swirl m55 unplug to w210 edc15c6 p1189 ?
thanks for all

29f800_originale.rar
File Type:
Downloaded:	68 times
Size:	166.83 KB

Hello m8s,
I need to change idle speed to 850-900.
Problem is shaking of the car when is cold...
I checked all, compresion, injectors, egf, flaps, ect
i can help for help... Many thanks..
kmlp

Attached Files

ori.zip
File Type:
Downloaded:	53 times
Size:	241.66 KB

Hello dear colleges
Im not sure if Im posting in right section of the forum.
If is not please moderators , help whit thread location.

Mi client have trouble whit his car in Milano Italia.
I need  mechanic there .
 some one who can diagnostic and repair the car
Renault Kangoo 1.5 dCi 2006, overheating and now the motor dont run 
More information in pm 
Thank you !

Hello everybody !
 Im suggesting, to make map whit geolocation for forum members.
Im from Nice Fr , if some one need help in my town to find me eazyly 
 Something like that

hi members i have a iaw4mv.fb   ecu seat leon 1.6  ecu nr 036 906 034 cp i need egr off i try wih ads to remove no succes i read and write with galleto do somebody have solution???

Attached Files

joosen iaw.rar
File Type:
Downloaded:	59 times
Size:	161.82 KB

I need help to remove immo on mini R56.
Virgin eeprom would help also!

MPC added

Thanks for any help!

Attached Files

R56MED172.rar
File Type:
Downloaded:	48 times
Size:	481 bytes

R56-394883.rar
File Type:
Downloaded:	47 times
Size:	696.49 KB

here is the last update
can clip v176

-----------------------------xiVZob!xSTTmoRYnC3QpCyso2VAIQ

and the key

!xSTTmoRYnC3QpCyso2VAIQ

Attached Files

Can Clip 176.txt
File Type:
Downloaded:	121 times
Size:	92 bytes

hello i am searching for someone who can tune tcu from Smart 451... or have a mappack.. help!

Hi Guys !

Does someone has this original file to share ?

BMW 320d E91 177hp - Bosch EDC17CP02

HW: 07812500
SW: 1037395778
VIN nr.: WBAVU51030A110022
SW ver.:
Spare: 07823831
Engine:
HW Ver.: 0281014238
SW upg.: 07823839
Installation:

Thank you !