Need some help with an issue which has been going on for some time with Case IH MXU135 PRO from 2005.
It looses power as driving or working, seems like safe mode.
Had diagnostic tool on it to capture the following codes:
SPN 3822 FMI 2 which according to SPN data is related to EGR, but I don’t see any EGR on this trator model, correct me if wrong as I am confused by this code showing up always as it goes into safe mode.
If I turn the engine off and back on, the engine starts runing ok,until it goes again into safe mode.
I also nave a SPN 190 FMI 1 code, which related to engine speed below normal range, but it may be related to crankshaft sensor, as it comes on after cranking on the engine, and notice it takes some time to start engine, but believe that is not the reason for the safe mode issue.
Going back to what I believe is the issue, is the SPN 3822 FMI 2 code, but since cannot find no EGR on this model, I need some help to figure out the origin foi this issue.
I noticed that turbo pressure being read via live diagnostic online goes up 200mBars above barometric pressure which 1000mBars, and when at full load, absolute pressure is at 1200mBars.
Maybe the MAP sensor is bad, triggering the safe mode and the SPN 3822 FMI 2 code because it detects that low pressure reading when it not?
Good day fellow mates.
Need some help here trying to find out the location and how to remove the ECM on a 2014 Caterpilar 428F backhoe.
Would appreciate the help so that I may remove it for sending to repair.
I have a BMW F30 3 Series which has had a CIC Navigation retrofit with an emulator fitted.
Car has come in from a friend with Radio/ Navigation switching off then booting and sticking on BMW Logo.
Can anyone help me with a solution to repair this, i know there are a few places on the net you can send the CIC to software update to fix but would like to learn how to do this myself. I am unable to update this unit in the car as it was not originally installed with it and ISTA just fails when trying.
Happy to make a donation for a working solution.
Hello, i need DTC off and CKS correction for Peugeot 307 1.4i 16V
It's about the second O2 sensor i want to delete it.
ECU: IAW6LP2.05
DTC: P0136-P0141