Hi, I need to exchange a SID208 ECU on a Peugeot Boxer. I know these can't be cloned.
I have Full reads of both ECU's and i know where the Immo Code is in both. Is it enough just to swap the code to the donor ECU eeprom or will it need checksum done also.
Is a Virgin file just the Immo code removed from the Eeprom (as i have seen this in some files ive checked, but not verified)
Both ECU's are the same Hardware number but different software. Again from experience can anyone confirm if its ok just to write the whole flash file over (Full Bench read)
Hi all i have a panasonic cf 19 mk5. i install w10 64 bit compete with latest update and drivers.
The problem is i have no sound, i try everything but not working.
I hope that someone here can help.
Ford Focus ST 250HP 2.0 2012 - NEED ORYGINAL DUMP or MAP FIX CORRECTION
need original dump or map fix
HW: BB5A-12B684-AC
SW: CM5A-12A650-AMK
The problem is that, first of all, the car started jerking, breaking off at idle. Between 1000rpm and 3000rpm the car breaks up, jerks. Above 3000rpm the car drives and accelerates well. Although I can see that it has lost some power. Everything (mechanically, sensors, etc.) has been checked in the car, only the engine controller map remains. The power was raised, but something spilled out and the car jerks at idle. I am asking for the original map or map correction. Once I test it and everything is ok, then I can pay for the help.